Filter
Top Products
E-16
SD-AT50(U)E2.fm02/7/19
SD-AT50
ENGLISH
7
DX-AT50
Preparation for Use
- System installation -
" Placing the speaker system
The best surround effect will be achieved by placing each speaker at the same dis-
tance from the listening position.
It is recommended to arrange the speakers as shown below.
Identify each speaker by the tube color.
Notes:
! Place the TV halfway between the front speakers.
! It is recommended that the center speaker be placed near the television.
! Place the surround speakers at a position just above the height of your ears.
! Set the subwoofer/amplifier unit on a stable, sturdy floor.
! If speakers cannot be placed at equal distances, refer to "Speaker delay setting".
(See page 41.)
! The speaker grille is not removable.
The speaker stands and speaker wall brackets are optionally available. (See page
51.) Refer to their manuals for assembly.
The speakers may be placed beside or near the TV as they are magnetically
shielded. However, color variation may occur, depending on the type of the TV.
If color variation occurs...
Turn off the TV (from the power switch).
After 15 - 30 minutes, turn the TV on again.
If the color variation is still present...
Move the speakers further away from the TV.
Refer to the user's manual of the TV for details.
Caution:
When moving the subwoofer/amplifier unit, be careful not to touch the speaker net
located near bottom. Be sure to hold it by the bottom to avoid subwoofer breakage.
Front
speaker (left)
(White)
Subwoofer/
Amplifier Unit
Front
speaker (right)
(Red)
Surround
speaker (left)
(Blue)
Surround
speaker (right)
(Gray)
Center
speaker
(Green)
Front speaker (left) (White)
Same distance
Front speaker (right) (Red)
Center speaker (Green)
Same distance
Speaker unit
Correct