Filter
Top Products
89
On-screen Error Messages
Messages Relating to DVD Discs
• The following messages appear on the TV screen in case the disc you tried to play back is not appropriate or
the operation is not correct.
CANNOT PLAY BACK THIS DISC.
THIS IS A NON-STANDARD DISC.
REGION CODE OF DISC IS WRONG.
DISC NOT INSERTED.
CANNOT OPERATE THIS FUNCTION.
DISC IS PROTECTED.
COULD NOT REPAIR THE DISC.
COULD NOT FINALIZE.
THIS VIDEO IS COPY PROTECTED.
RECORDING IS NOT POSSIBLE.
CANNOT RECORD MORE.
CANNOT RECORD ON THIS DISC.
COULD NOT INITIALIZE.
DISC IS FULL.
CANNOT RECORD OR STORE.
CANNOT RECORD VIDEO TO THIS
DISC.
SET THE DATE AND TIME.
• The disc cannot be played with this
Recorder.
• If you load a disc which cannot be
played with this Recorder (i.e. a
scratched disc), or if you load a
disc upside down, this message will
appear, and the disc tray will
automatically pop out.
• Occurs if you load a DVD disc
whose region number is not “ALL”
or whose region number does not
contain “1”.
• Occurs if no disc is loaded in the
disc tray.
• Occurs if operation is incorrect.
• Occurs if you attempt to record or
edit a disc for which disc protection
is set.
• If there is a power failure during DVD
recording, the system automatically
tries to recover data after power is
restored. This error occurs if such
recovery is impossible.
• Occurs if the disc is scratched or
dirty, etc.
• Occurs if video with a copy guard
signal is input.
• Occurs if a title or chapter mark
exceeds the recordable upper limit.
• Number of titles: 99.
Number of chapters:999
• Occurs if you load a disc which
cannot be recorded to with this
Recorder, or a disc which is
scratched or dirty.
• Occurs if the disc is scratched or
dirty, etc.
• Occurs if there is no empty space in
the disc.
• Occurs if you try to record a “Copy
Once” broadcast onto a disc which
is not compatible with CPRM.
• Occurs if timer programming is
done when the Recorder clock has
not been set.
• Check the disc, and load it
correctly.
• Cancel disc protection, or reload a
recordable disc.
• Check the disc, and load it
correctly.
• Cannot record.
• Erase unnecessary titles.
• Either erase unnecessary chapters,
or combine chapters.
• Reload an appropriate recording
disc.
• Check the disc, and load it correctly.
• Load a disc with empty space.
• Erase unnecessary titles.
• Load a CPRM compatible disc
(DVD-RW Ver. 1.1 or higher)
initialized in VR mode.
• Set the clock and perform timer
programming again.
Error message
Possible Error Suggested Solution
Continued on Next Page
|||