Filter
Top Products
66
Appendix
• No power.
• Unit cannot be operated.
• Remote control unit does not
operate.
• Picture is cut off.
• Strange colour, light colour, or
dark, or colour misalignment.
• Power is suddenly turned off.
• No picture.
• No sound.
Problem Possible Solution
• Make sure the Display and the AVC System are connected correctly. (See page
9.)
• Check if you pressed POWER on the remote control unit. (See page 19.)
If the indicator on the Display lights up red, press POWER on the display.
• Is the AC cord disconnected? (See page 15.)
• Has the main power been turned on? (See page 19.)
• External influences such as lightning, static electricity, etc., may cause improper
operation. In this case, operate the unit after first turning the power off the Display
and the AVC System, or unplugging the AC cord and re-plugging it in after 1 or
2 minutes.
• Are batteries inserted with polarity (e, f) aligned? (See page 14.)
• Are batteries worn out? (Replace with new batteries.)
• Are you using it under strong or fluorescent lighting?
• Is a fluorescent light illuminated to remote control sensor?
• Is the image position correct? (See page 51.)
• Are screen mode adjustments such as picture size made correctly? (See pages
54 to 57.)
• Adjust the picture tone. (See pages 31 to 33 and 57.)
• Is the room too bright? The picture may look dark in a room that is too bright.
• Check the colour system setting. (See pages 27 and 53.)
• Check the input signal setting. (See page 52.)
• The unit’s internal temperature has increased.
Remove any objects blocking vent or clean.
• Check the power control setting. (See page 35.)
• Is sleep timer set? (See page 59.)
• Is connection to other components correct? (See pages 47 to 49.)
• Has input signal setup been done correctly after connection? (See page 52.)
• Is the correct input selected? (See page 52.)
• Is a non-compatible signal being input? (See page 67.)
• Is picture adjustment correct? (See pages 31 to 33.)
• Is the antenna connected properly? (See page 15.)
• Is “On” selected in “Audio Only”? (See page 51.)
• Is the volume too low? (See page 22.)
• Is “Variable” selected in “Audio Out”? (See page 59.)
• Is the speaker connected properly?
• Is correct speaker output (“SPEAKER-A” or “SPEAKER-B”) selected in “Speaker”?
(See page 50.)
• Is “On” selected in “Centre Channel Input”? (See page 61.)
• Make sure that headphones are not connected. (See page 17.)
Troubleshooting
Cautions regarding use in high and low temperature environments
• When the unit is used in a low temperature space (e.g. room, office), the picture may leave trails or appear
slightly delayed. This is not a malfunction, and the unit will recover when the temperature returns to normal.
• Do not leave the unit in a hot or cold location. Also, do not leave the unit in a location exposed to direct sunlight
or near a heater, as this may cause the cabinet to deform and the LCD panel to malfunction.
Storage temperature: –20°C to +60°C (–4°F to +140°F).
LC-32/37G2X-K 04.5.22, 0:03 PM66