Filter
Top Products
58
Re-recording a picture in the middle of a
recorded tape
You can insert a scene in the middle of a recorded tape by setting the starting and
ending points. The previous recorded portion will be erased.
(1) While the digital camcorder is in Standby mode, keep pressing the + (forward
playback) or – (reverse playback) side of EDITSEARCH, and release the button
where you want to end the insertion [b]. The digital camcorder enters Standby
mode again.
(2) Press ZERO SET MEMORY.
The counter is reset to “0:00:00”.
“ZERO SET MEMORY” flashes and the ending point is stored in memory.
(3) Hold down the – side of EDITSEARCH until the digital camcorder goes back to the
point where you want to start the insertion [a].
(4) Press START/STOP to start re-recording. The insert recording stops automatically
at the counter zero point, and the digital camcorder enters Standby mode again.
Zero set memory resumes automatically.
EDITSEARCH
[a]
[b]
1
3
4
2
ZERO SET
MEMORY
ZERO SET
MEMORY
START/STOP
LOCK
STANDBY
PHOTO
STANDBY
EDITSEARCH
To change the end point
Press ZERO SET MEMORY so that “ZERO SET MEMORY” disappears.
Repeat steps 1 to 3.
Notes on editsearch
• The picture may be distorted at the end of the inserted portion when it is played back.
• Zero set memory may not function when there is a blank portion between pictures on
a tape.
• You can re-record without using the zero set memory. Skip steps 1 and 2. Press
START/STOP to stop recording.