Filter
Top Products
63
Advanced operations
Editing onto another tape
Edición en otra cinta
Notes on editing when using the DV connecting cable
• You can connect one VCR only.
• Connect the l LANC jacks when controlling this digital camcorder from another
VCR for editing.
• If you recorded the playback pauses picture via the DV jack, the recorded picture
becomes rough.
• You can use this digital camcorder as a recorder.
In this case, you do not need to change the DV connecting cable’s connection since the
direction of signal flow changes automatically, make sure that “DV IN” appears on
the TV and/or in the viewfinder.
When you use this digital camcorder as a recorder
Cassette memory data is not recorded.
Starting editing
(1) Set the POWER switch to ON and then set CAMERA/VTR to VTR.
(2) Insert a blank tape (or a tape you want to record over) into the recording VCR.
Then insert your recorded tape into the digital camcorder.
(3) Play back the recorded tape on the digital camcorder until you locate the point
where you want to start editing. Then set the digital camcorder to playback pause
mode.
(4) Set the recording VCR to recording pause mode.
(5) Press P on the digital camcorder and VCR simultaneously to start editing.
To edit more scenes
Repeat steps 3 to 5.
To stop editing
Press π on the digital camcorder and VCR.
Note on editing when using the A/V connecting cable
Press DISPLAY on the Remote Commander while editing onto another tape to turn off
the display indicators. Otherwise, the indicators will be recorded on the tape.
Note on Fine Synchro Edit
If you connect a VCR that has the Fine Synchro Edit feature to the l LANC jack of the
digital camcorder using a LANC cable (not supplied), the edit will be even more
precise.