Filter
Top Products
7
Getting started
Charging and installing the battery pack
Before using your digital camcorder, you first need to charge and install the battery
pack (not supplied). To charge the battery pack, use the AC-V615 AC power adaptor
(not supplied).
This digital camcorder does not interface with “InfoLITHIUM” batteries. The
remaining time (minutes) indication does not appear when using “InfoLITHIUM”
batteries.
Charging the battery pack
Charge the battery pack on a flat surface without vibration.
(1) If your AC power adaptor is direct type, pull down the plug. If it is inlet type,
connect the power cord to the AC power adaptor.
(2) Align the surface of the battery pack indicated by the z mark with the edge of the
terminal shutter of the AC power adaptor. Then fit and slide the battery pack in the
direction of the arrow.
(3) Connect the AC power adaptor to a wall outlet. The CHARGE lamp (orange) lights
up. Charging begins.
When the CHARGE lamp goes out, normal charge is completed. For full charge,
which allows you to use the battery longer than usual, leave the battery pack in place
for approximately one hour. Unplug the unit from the wall outlet, then remove the
battery pack and install it into the digital camcorder. You can also use the battery pack
before it is completely charged.
1
32
or
CHARGE
Charging time
Battery pack Charging time* (min.)
NP-F730** 250 (190)
NP-F750 270 (210)
NP-F930 330 (270)
NP-F950 360 (300)
The time required for a normal charge is indicated in parentheses.
* Approximate minutes to charge an empty battery pack using the AC-V615 AC power
adaptor. (Lower temperatures require a longer charging time.)
**Some battery packs may not be supplied in some country.