Filter
Top Products
Chapter 2 Recording and Playback
Chapter 2 Recording and Playback 25
The cassette is automatically drawn into the unit and the tape is wound
round the head drum. The tape is stationary while the head drum
rotates, and the STOP button lights.
If the REC INHIBIT indicator lights:
It indicates that the loaded cassette’s REC/SAVE switch has been set
to SAVE. Press the EJECT button in the tape transport control section
to remove the cassette, then set the cassette’s REC/SAVE switch to
REC and reload the cassette.
Note
Make sure that the unit’s power is on when ejecting and loading
cassettes.
2 Press and hold the REC button, and press the PLAY button.
This puts the unit into recording mode, and the tape starts moving.
3 Press the PLAY button on the player.
This starts the player’s playback operation, at which point this unit
starts recording the input playback signals.
Cautions
• Once you have started recording, you cannot change the audio mode
selection.
• If on a tape there is a point where the audio mode is switched, you cannot
perform an insert editing on that tape.
Standard size
Tape window facing upward
Mini size
Insert the mini-size cassette into
the middle of the cassette
compartment.