Filter
Top Products
Chapter 1 Overview
Chapter 1 Overview 9
1 Display section (A) and video/audio input setting section
AUDIO INPUT LEVEL AUDIO REC
SELECT
2CH/4CH
INPUT SELECT
VIDEO AUDIO
QSDI
CH-1
CH-1/2
CH-2
CH-3/4
dB
0
-12
-20
-30
-40
-60
CH-1
AUDIO MODE INPUT MODE
VIDEO
AUDIO
CH-1,1/2 CH-2,3/4
COMPOSITE
ANALOG ANALOG
S VIDEO
COMPONENT
SDI
AES/EBU
SDI
AES/EBU
SDI
2CH
4CH
Fs44.1k
Fs48k
Fs32k
QSDI
CH-2 CH-3 CH-4
CH-1 CH-2 CH-3 CH-4
0
2
46
8
10
0
2
46
8
10
0
2
46
8
10
0
2
46
8
10
OVER
dB
0
-12
-20
-30
-40
-60
OVER
dB
0
-12
-20
-30
-40
-60
OVER
dB
0
-12
-20
-30
-40
-60
OVER
[2CH] and [Fs48k] indicators: Light during playback
of a tape recorded in two-channel mode (48 kHz),
or during two-channel mode (48 kHz) recording.
[2CH] and [Fs44.1k] indicators: Light during
playback of a tape recorded in two-channel mode
(44.1 kHz).
[4CH] and [Fs32k] indicators: Light during playback
of a tape recorded in four-channel mode (32 kHz),
or during four-channel mode (32 kHz) recording.
1 Audio level meter
2 AUDIO MODE display
3 INPUT MODE display
4 INPUT SELECT buttons
5 AUDIO REC SELECT button
6 AUDIO INPUT LEVEL control
knobs
1 Audio level meter
Indicates the recording level during recording or EE
mode
1)
and the playback level during playback. When
the audio level exceeds 0 dB, the OVER indicator
lights.
The short bars to the left of some level indication bars
indicate that those levels are reference audio recording
levels.
2 AUDIO MODE display
Indicates the audio mode during playback or recording
or while in EE mode.
• During playback it indicates the audio mode in which
the tape was recorded.
• During recording or while in EE mode, it indicates
the currently selected audio recording mode. The
AUDIO REC SELECT button is used for audio
recording mode selection.
........................................................................................................................................................................................................
1) EE mode
“EE” stands for “Electric to Electric”. When in this
mode, the video and audio signals that are input to the
VCR’s recording circuitry do not pass through any
magnetic conversion circuits but instead are output via
electric circuits only. This mode is used to check input
signals and adjust input levels.