Filter
Top Products
48 Chapter 4 Menu Settings
Chapter 4 Menu Settings
Menu Contents
TC EE OUT MODE settings
Use the following as reference information when
setting “TC EE OUT MODE” (see page 46).
• THROUGH mode
In this mode, the LTC signal is output with the phase
synchronized to the input timecode signal, and is
appropriate when recording signals from multiple
devices on a number of VCRs.
When the camcorder is in genlock mode the timecode
precision is ±0 frames, and when not in genlock
mode is ±1 frame.
VIDEO IN
AUDIO IN
TIME CODE IN
TIME CODE OUT
VIDEO IN
AUDIO IN
TIME CODE IN
TIME CODE OUT
VIDEO IN
AUDIO IN
TIME CODE IN
TIME CODE OUT
Composite video or S-video signal
Audio signal
Timecode signal
• VIDEO INPUT PHASE mode
The timecode output signal is synchronized to the
input video signal.
This mode is appropriate when the output from a
single device is recorded on a number of VCRs. The
connections are loop-through connections.
In this mode, the same timecode is recorded on all of
the VCRs 1 to n.
VIDEO INVIDEO OUT
VIDEO LOOP THRU
TIME CODE IN
TIME CODE OUT
VIDEO IN
VIDEO LOOP THRU
TIME CODE IN
TIME CODE OUT
VIDEO IN
VIDEO LOOP THRU
TIME CODE IN
TIME CODE OUT
Composite video or SDI (video and audio) signal
Timecode signal
Camcorder 1
DSR-85/85P (1st unit)
Camcorder 2
DSR-85/85P (2nd unit)
Camcorder n
DSR-85/85P (nth unit)
Input device
(VCR, camera, etc.)
DSR-85/85P (1st unit)
DSR-85/85P (2nd unit)
DSR-85/85P (nth unit)