Filter
Top Products
125
Settings and Adjustments
Selects the colour system when recording
from the connected equipment.
b Notes
• When picture noise appears after you change the
“Input Line System” setting, change the “Input
Colour System” setting (page 130). If picture
noise still appears, hold down x (stop) on the
recorder, and press INPUT on the recorder.
• When you change the “Input Line System”
setting, the Dubbing List is erased.
Selects whether this recorder is in power
save mode when the power is turned off
(standby).
b Note
Power Save mode does not function in the
following cases, even when “Power Save” is set to
“Mode 1” or “Mode 2.”
– There is a timer setting with “VPS / PDC” in the
schedule list or Timer List.
– The SMARTLINK features are not available
when “Power Save” is set to “Mode 1” or “Mode
2.”
Selects the EPG (Electronic Programme
Guide) type to use.
The default setting varies depending on the
country/region.
Select this to run the “Easy Setup”
programme.
Follow the instructions for “Easy Setup”
(page 30) from step 2.
Input Line System
NTSC Records in NTSC or PAL-60
colour system.
PAL/
SECAM
Records in PAL or SECAM
colour system.
Power Save
Mode 1 Only aerial input signals are
output to the connected TV
when the recorder is in
standby.
Mode 2 No input signals are output
when the recorder is in
standby.
Off
Does not set to power save
mode. Normally, select this
setting.
HELP Setting
On Displays Help information for
GUI displays.
Off Does not set to HELP setting
mode.
EPG Type Select
GUIDE
Plus+
Select this to use the Gemstar
GUIDE Plus+ electronic
programme guide (page 61).
Guide
(Digital)
Select this to use the digital
electronic programme guide
(page 50).
Easy Setup (Resetting the
Recorder)