Sony RDR-HXD995 DVD Recorder User Manual


 
21
Hookups and Settings
About the set top box receiver control function (in areas with GUIDE Plus+ only)
You can use the set top box receiver control function with hookup C.
When using the set top box receiver control function:
– The recorder controls the set top box receiver via the supplied set top box controller.
– The recorder controls programme positions on the set top box receiver for timer recording.
– You can use the recorder’s remote control to change programme positions on the set top box
receiver whenever the set top box receiver and recorder are turned on.
After making hookup C, check that the recorder correctly controls the set top box receiver
(page 32).
Use this hookup if you watch cable programme positions without a set top box receiver. Also
use this hookup if you are only connecting an aerial antenna.
With this hookup, you can record any programme position by selecting the programme
position on the recorder.
1 Disconnect the aerial cable from your TV, and connect it to ANALOG AERIAL IN on
the rear panel of the recorder.
2 Connect ANALOG AERIAL OUT of the recorder to the aerial input of your TV using
the supplied aerial cable.
D: Receiving terrestrial (For analogue broadcasting)
DVD recorder
TV
to aerial input
to ANALOG AERIAL IN
to ANALOG AERIAL OUT
Aerial cable (supplied)
: Signal flow
Wall