Filter
Top Products
18
Step 1: Connecting the Aerial Cable and Set Top Box
Controller
b Notes
• If your aerial is a flat cable (300-ohm twin lead cable), use an external aerial connector (not supplied) to
connect the aerial to the recorder.
• If you have separate cables for AERIAL antennas, use an AERIAL UHF/VHF band mixer (not supplied)
to connect the aerial to the recorder.
• If you disconnect the recorder’s mains lead, you will not be able to view the signals from the connected
set top box receiver.
Use this hookup if you can receive Freeview.
With this hookup, you can record any programme position by selecting the programme
position on the recorder.
1 Disconnect the aerial cable from your TV, and connect it to DIGITAL AERIAL IN on
the rear panel of the recorder.
2 Connect DIGITAL AERIAL OUT of the recorder to the aerial input of your TV using the
supplied aerial cable.
z Hint
For RDR-HXD795/HXD895/HXD995/HXD1095 (except models for the UK) only
When connecting to an indoor aerial, use one with a signal amplifier rated at 5 V, 30 mA. Then set “Aerial
Power” to “On” in the “Digital Tuner” setup (page 127).
A: Receiving Freeview (For digital broadcasting)
DVD recorder
TV
to aerial input
to DIGITAL AERIAL OUTto DIGITAL AERIAL IN
Aerial cable (supplied)
: Signal flow
Wall