Filter
Top Products
16
Using Non-Preset Remote Control
Operations — Learning Function
(continued)
To clear all signals learned for a
specific component
1 While pressing COMMANDER
OFF, press the corresponding
Component Select button.
When you want to clear signals
learned for DECK B/A
Press DECKB/A to display “DECK A”or
“DECK B”. You can not clear both decks at
the same time.
2 While pressing the RESET key,
press that Component Select
button again. The Commander
beeps, the learned contents are
cleared. The keys for the
component return to their
original states before learning.
Note
If you perform the steps above when no signal
is “learned”, the component code setting (page
8) will be reset to the factory setting.
Note that for DECK B/A, if you reset either
deck (A or B), the component code for both A
and B will be reset to the factory setting.
Changing or erasing the
function of a learned key or
button
To change the learned function, clear it
first and perform learning again.
To clear the learned function of a
single key or button
1 After Step 2, while pressing the
RESET key, press the key or
button you want to erase.
The cleared key flashes together with
other learnable keys.
COMMANDER
OFF
+
CD
+
RESET
+
RESET
CD