Filter
Top Products
21
If a series of commands is already
programmed on that button
That program will be displayed. (Note
that the SYSTEM CONTROL 3 button
is factory preset with standard Power-
on Command for nearly all Sony
Components.) To program a new
series of operations, clear the program
first (see page 23).
2 Press the Component Select
buttton for the component to
operate.
The keys for the selected component
flash.
3 Press key(s) or button(s) for the
desired operation.
The remote control signal for the
pressed key is transmitted, so you can
check that each component actually
operates the way you want.
TV
POWER
4 Repeat Steps 2 and 3 and
program the buttons and keys for
the series of operations.
In this example, press the following
buttons and keys.
5 When you have programmed all
the keys, press COMMANDER
OFF.
Notes
• If you interrupt the procedure at any point
for over two minutes, the setting mode ends
and the series of commands will be
programmed to that point. In this case, clear
the program and start again from Step 1 to
set the entire program from the beginning.
You can not continue from where you let off.
• If a SYSTEM CONTROL button has already
“learned” a remote control signal (see page
29), “NG”flashes and you hear a beep to
inform you that you can not program on this
button. Clear the learned contents first (see
page 30).
•If you change the component code number
(page 8) or program a new signal by learning
(page 13) on a key or button that has been
programmed in the series of commands of
the System Control function, the new signal
will be transmitted when you press the
corresponding SYSTEM CONTROL button.
COMMANDER
OFF
Continued
VCR1
m
POWER
m
POWER
TV
TV/VIDEO
m
VIDEO1
AMP
m
VCR1
m
m
m
m
LEARNNG
C+C- V+ V-
MU
TV
RESET
123
456
78
0
9
ENTER
TV/VIDEO
RECALL
P IN P
DISPLAY
POWER
EXECUTE
WIDE
SLEEP
MENU