Filter
Top Products
19
Notes
• If you have programmed any signal on the
VOLUME or MUTING buttons by learning
(page 13) for certain components, that signal
will be transmitted instead of controlling the
volume of TV or amplifier when you select
that component.
• When the VOLUME or MUTING buttons of
TV or AMP have “learned” any signal, that
signal will be transmitted only when you
select TV or AMP. When you select other
components, the original signals preset for
TV or AMP will be transmitted.
To change the Factory Preset of
the Volume Control
However, if your visual components are
connected to an audio system, you
probably hear TV or VCR sound from the
loudspeakers via your amplifier, not
from your TV speakers. In this case, you
need to change the factory preset so that
you can control the volume of your
visual components without first having
to switch to the amplifier.
SYSTEM CONTROL COMMANDER
OFF
LIGHT
TV VCR1 VCR2 VCR3 DVD DBS/CBL
AMP CD MD/DAT DECK B/A TUNER OPTION
CHANNEL VOLUME
MUTING
–
+
–
+
≠
±
123
1
COMMANDER
OFF
++
VOLUME
+
–
1 While pressing COMMANDER
OFF, press VOLUME + and
VOLUME –.
You hear a beep and the volume
control setting of visual components
(TV,VCR1,2 and 3, DBS/CBL, and
DVD) changes to the displayed
component.
Notes
• If you have already programmed the
VOLUME or MUTING button of each
component any signals by “learning”, the
procedure above will not change the function
of the VOLUME and MUTING buttons.
• If you have programmed volume control
signals on VOLUME or MUTING buttons of
TV or AMP, you can only use that signal
when you select TV or AMP. For other
component, the preset volume control signals
for TV or AMP (depending on the above
setting procedure) will be transmitted. To use
the new signals, you need to program each
button for each component by the learning
procedure (page 13).
When set to
amplifier volume
When set to
TV volume
V+ V–
MU
TV
V+ V–
MU
AMP