Filter
Top Products
26
Turning Off the Power
of All Components by a
Single Button
Operation
— System Power-Off Function (for
Sony Components only)
When the System Power-Off function is
active, you can turn off all Sony
components just by pressing the
COMMANDER OFF button for three
seconds.
To set the System Power-Off
function
1 While pressing COMMANDER
OFF, press CHANNEL - and
VOLUME +.
When the System Power-Off function
is set, “POWER OFF” appears on the
display. (The display goes off when
you release the buttons.)
To cancel the System Power-Off
function
Repeat the procedure above. The
following display appears when the
System Power-Off function is disabled.
POWER
OFF
POWER
4 Press and hold down the button
on the component’s remote
control (amplifier in this example)
until you hear a beep.
5 Press COMMANDER OFF.
To clear the learned function of
the Component Select button
1 While pressing COMMANDER OFF,
press VOLUME+ and CHANNEL+.
2 While pressing the RESET key, press
the Component Select button which
you want to clear.
Note
• Even if that Component Select button has
been programmed with the Power-on
command (page 24), you can program any
signal on it by the procedure above.
However, the new signal overwrites the
Power-on command, and even after you clear
this new signal, the Power-on command will
not resume.
COMMANDER
OFF
Adding an Extra Function to the
Component Select Buttons
(continued)
COMMANDER
OFF
++
CHANNEL VOLUME
–+
INPUT SELECT
CD