Filter
Top Products
13
EN
Continued
Example: To program the (
(Play) signal of your component
to the VCR1 ( (Play) key of the
Commander
1 Place the RM-AV2000T head to
head with your component’s
remote control.
2 While pressing COMMANDER
OFF, press the Component Select
button for the component whose
signals are to be learned.
All the learnable keys flash.
Display for PROGRAM, Á and ¤ buttons
The “P+ P– V+ V– MU” display
indicates if PROGRAM +/–, Á +/–
and ¤ buttons are learnable or not.
Note on the flashing display
The keys or buttons that are already preset
for that component flash twice while those
that are not preset flash once.
about 5 – 10 cm
(2 – 4 inches)
away
RM-AV2000T
Remote control for
your component
COMMANDER
OFF
+
VCR1
P
+
P
–
V
+
V
–
MU
VCR1
RESET
123
456
78
0
9
2
-
-/--
1
-
ANT SW
INPUT
u
REC
LEARNNG
3 Press the key or button on the
Commander you want to “teach”.
“LEARN” flashes and the only
pressed key remains on the display.
To teach on the PROGRAM +/–,
Á +/– or ¤ buttons
Press the corresponding button. “LEARN”
flashes, “P+”, “P–”, “V+”, “V–”, or “MU”
remains on the display.
4 Press and hold down the button
of your component’s remote
control until you hear a beep.
“LEARN” stops flashing and stays lit.
When the signal has been learned
successfully, the learned keys stay lit
and the other learnable keys flash.
If you hear beeps and “NG”
flashes on the display
Learning did not succeed. Try Steps 3 and
4 again.
Certain signals may require the learning
procedure more than once to complete
learning. In this case, try Step 4 again if
“NG” appears after Step 4.
VCR1
LEARNNG