Filter
Top Products
25
EN
Turning Off the Power
of All Components by a
Single Button
Operation
— System Power-Off Function (for
Sony Components only)
When the System Power-Off function is
active, you can turn off all Sony
components just by pressing the
COMMANDER OFF button for three
seconds.
To set the System Power-Off
function
1 While pressing COMMANDER
OFF, press PROGRAM – and
Á +.
When the System Power-Off function
is set, “u OFF” appears on the
display. (The display goes off when
you release the buttons.)
To cancel the System Power-Off
function
Repeat the procedure above. The
following display appears when the
System Power-Off function is disabled.
4 Press and hold down the button
on your component’s remote
control (amplifier in this example)
until you hear a beep.
5 Press COMMANDER OFF.
To clear the learned function of
the Component Select button
1 While pressing COMMANDER OFF,
press Á + and PROGRAM +.
2 While pressing the RESET key, press
the Component Select button which
you want to clear.
Note
Even if that Component Select button has been
programmed with the Power-on command
(page 23), you can program any signal on it by
the procedure above. However, the new signal
overwrites the Power-on command, and even
after you clear this new signal, the Power-on
command will not resume.
INPUT SELECT
CD
COMMANDER
OFF
u
OFF
u
COMMANDER
OFF
++
PROGRAM
–
=
+
Á