Filter
Top Products
35
EN
Troubleshooting
If you have problems setting up or using the Remote Commander, first check the
batteries (page 5), then check the items below.
Remedy
• Go closer to the component. The maximum operating distance is
approximately 10 m (32.8 ft).
• Check that you are aiming the Commander directly at the compoent,
and that there are no obstructions between the Commander and the
component.
• Power on the components first, if necessary.
• Make sure you have pressed the correct Component Select button. In
case of SAT/CBL, DVD or DECK B/A, make sure the desired
component is displayed.
• Check that the component has infrared remote capability. For example,
if your component didn’t come with a remote commander, it probably
isn’t capable of being controlled by a remote commander.
• If your visual components are connected to an audio system, make sure
you’ve set up the Commander as described in “Controlling the Volume
of Visual Components Connected to an Audio System”. (page 17)
• Set the component code correctly (page 7). If the code that is listed first
for your component doesn’t work, try all the codes for your component
in the order in which they are listed in the supplied “Component Code
Numbers”.
• Some features may not be preset. If some or all of the keys do not
function correctly even after you have set the component codes, then
use the learning function to program the remote control signals for the
component. (page 12)
• Make sure that the Remote Commander has learned the correct signals.
If not, try the learning procedure again. (page 12)
• Clear infrequently used learned keys (page 15), then carry out learning
operations.
• See “For accurate learning” on page 14 and try the learning procedure
again. (page 12)
• Another remote control signal has been already programmed on that
key or button by the learning function. Clear learned functions (page
15) and then try the learning procedure again. (page 12)
Symptom
You cannot operate the
components.
You cannot operate the
components even after
setting the component
code numbers.
You cannot operate a
component even after
you programmed the
remote control signals
with the “learning”
function.
“NG” flashes during
learning.
“NG” displays during
learning.
Continued