Filter
Top Products
36
EN
Symptom
A system control
program does not
function correctly.
The power of the
Commander turns off by
itself.
Remedy
• Make sure that you have programmed the commands in the correct
order. (page 18)
• Try changing the orientation of the Commander. If that does not help,
try placing the components as close to each other as possible.
• Check the status of the components and make sure that you have set the
components properly to receive commands from the SYSTEM
CONTROL buttons.
• This Commander is preset at the factory to switch the power off
automatically after 10 minutes if left unused. (Auto Power-Off, page 32)
You can change the power-off time from 10 to 90 minutes, or set the
Commander not to power off automatically.
Troubleshooting (continued)