Filter
Top Products
Other Information
52
Programming the Remote Control
The remote control is preset to operate Sony-brand video equipment.
If you have video equipment other than Sony brand that you want to
control with the TV’s remote control, use the following procedure to
program the remote control.
1 Check the list of “Manufacturer’s Codes” on page 53, and find
the three-digit code number for the manufacturer of your
component. (If more than one code number is listed, use the
number listed first.)
2 Press CODE SET.
3 Press the function button for the type of component you want to
control with the TV’s remote control (VCR/DVD or SAT/
CABLE).
4 Enter the three-digit manufacturer’s code number.
5 Press ENTER.
6 To check if the code number works, aim the TV’s remote control
at the component and press the green POWER button that
corresponds with that component. If it responds, you are done. If
not, try using another code listed for that manufacturer.
Sony
Equipment
Switch Position
on Remote Control
Programmable
Code Number
Beta, ED Beta VCRs AV1 303
8 mm VCR AV2 302
VHS VCR AV3 301
DVD Player DVD 751
✍ The equipment must have infrared (IR) remote capability in order to be used
with the remote control.
✍ You must do step 4 within 10 seconds of step 3, or you must redo
steps 2 and 3.
❑ If more than one code
number is listed, try
entering them one by
one until you come to
the correct code for
your component.
❑ If you enter a new code
number, the code
number you
previously entered at
that setting is erased.
❑ In some cases, you may
not be able to operate
your component with
the supplied remote
control. In such cases,
use the component’s
own remote control
unit.
❑ Whenever you remove
the batteries to replace
them, the code
numbers may revert to
the factory setting and
must be reset.
z