Filter
Top Products
7
Connecting Your Digital
Satellite Receiver
Follow the procedures or ma ke the connections in
each of the steps to connect your Digital Satellite
Receiver.
Before you can use the remote control, you must
insert the supplied batteries. If you want to use this
remote control to operate other audio/video
equipment, such as a TV or VCR, you must set up the
remote control (see page 65).
1 Push and slide open the battery
compartment.
2 Insert two size AA batteries
(supplied).
Be sure to match the + and – marks on the
batteries with the + and – marks inside the battery
compartment.
Notes
• When the batteries become weak, the Function button
indicators flash. If the remote co ntro l does not wo rk
properly, the batteries may be weak.
• When replacing batteries, replace both batteries with new
ones. Do not mix different types of batteri es togeth er.
• When you remove the batteries, any manufacturer codes
you’ve set up may be erased. To set up the remote control
again, see “Setting Up the Remo te C on trol” o n pa ge 65.
v
v
v
v
v
v
v
Step 1: Inserting the Batteries
Page 7
Step 2: Connecting the Satellite
Dish Antenna and
Telephone Line
Page 8
Step 2: Connecting the Satellite
Dish Antenna and
Telephone Line
Page 8
Step 3: Connecting Your TV
Page 9
Step 4: Adding a VCR and
Audio System
(advanced connection)
Page 10
Step 5: Connecting the VCR
Controller
(advanced connection)
Page 11
Step 6: Connecting the RF
Antenna (SAT-A55 only)
(advanced connection)
Page 12
Step 7: Connecting the AC
Power Cord
Page 13
Step 8: Inserting the Access
Card
Page 13
Connection
Overview
Step 1: Inserting the
Batteries