76
Your Digital Satellite R eceiver has been registered by the Federal
Communication Commission (FCC) as not being harmful to the
telephone network when connected directly to the telephone lines.
In order to fully comply with the Rules of the FCC, the following
instructions should be read carefully and followed compl etely
where applicable:
1 The Federal Communication Commission (FCC) has
established Rules which permit this device to be directly
connected to the telephone network. Standardized jacks are
used for these connections.This equipment should not beused
on party lines or coin phones.
2 If this device is malfunctioning, it may also be causing harm to
the telephone network; this device should be disconnected
until the source of the problem can be determined and until
repairhasbeenmade.Ifthisisnotdone,thetelephone
company may temporarily disconnect service.
3 The telephone company may make changes in its technical
operations and procedures; if such changes affect the
compatibility or use of this device, the telephone company i s
required to give adequate notice o f the changes. You will be
advised of your right to file a complaint with the FCC.
4 If the telephone company requests information on what
equipment is connected to their lines, inform them of:
a. The telephone number to which this unit is connected.
b. The ringer equivalence number.
c. The USOC jack required.
d. The FCC Registration Number.
5 Items (b) and (d) are indicated on the label. The Ringer
Equivalence Number (REN) is used to determine how many
devicescan be connected to your telephone line. In most areas,
thesumoftheRENsofalldevicesonanyonelineshouldnot
exceed five (5). If too many devices are attached, they may not
ring properly.
Service Requirements
In the event of equipment malfunction, all repairs should be
performed by our Company or an authorized agent. It is the
responsibility of users requiring service to report the need for
servicetoourcompanyortooneofourauthorizedagents.For
service, call 1-800-838-7669.
Radio Interference Information
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference w ill not o ccur in
a particular installation. If this equipment does cause interference
to radio or television reception (which yo u can determine by
turning the equipment off and on), you are encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna (the antenna for radio
or television that is receiving the interference)
• Change the position of the Digital Satellite Receiver with respect
to the radio or television equipment that is receiving the
interference
• Move the Digital Satellite Receiver away from the equipment
that is receiving the interference
• Plug the Digital Satellite Receiver into a different outlet so that
the Digital Satellite Receiver and the equipment r eceiving the
interference are on different branch circuits
Shielded cables and I/O cords must be used for this equipment to
compl y with the relevant FCC regulations. Changes or
modifications not expressly approved in writing by Sony
Electronics, Inc., void the user’s authority to operate this
equipment.
If these measures do not eliminate the interference, you should
consult your Digital Sa tellite Receiver dealer or an experienced
radio/televi sion technician for additional suggestions. In
addition, you may find the following booklet prepared by the
Federal Communications Commission helpful: “How to Identify
and Resolve Radio-TV Interference Problems.” This booklet i s
available from the U.S. Government Printing Office, Washington,
D.C., 20402 Stock No. 004-000-00345-4.
Declaration of Conformity
Trade Name: Sony
Model No.: SAT-A55/SAT-B55
Responsible Party:Sony Electronics Inc.
Address: 1 Sony Drive, Park Ridge, NJ. 07656 USA
Telephone No.: 201-930-6970
This device complies with Part 15 of the FCC rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interferen ce, and (2) this device must accept
any interference received, i ncluding interference that may
cause undesired operation.
FCC Regulations and Information