Filter
Top Products
113
5. Appendix
5.1 Installing HDD
5.1.1 Installing single hard disk drive
The following procedure is for installing either one internal HDD or one removable HDD.
Please note that the Jumper setting must be set to MASTER.
To Install a single HDD in the Removable Bay, please follow these steps
Prepare one HDD. Verify the Jumper setting. It must be set to “Master”.
Jumper Setting
(Master)
Open the cover of the Removable Bay. Connect the HDD power cable and the Data
signal cable.
Power Data
Insert the HDD in the Rack and close the cover.