Filter
Top Products
32
8. DVR-16IP Remote Access of Video over the Web
This section discusses the remote control ability of DVR-16/IP; it is an optional function. Users
are able to access live and recoded video from remote site through Internet with Ethernet port
connected. Key in the correct IP address, and then below control panel will appear on your
computer screen. Through the control panel, users are allowed to control and setup the OSD
settings of DVR-16/IP and connected speed dome remotely.
8.1 Button Introduction
1. Zoom In/ Zoom Out
If the DVR-16/IP has connected with any dome cameras, you can zoom in or zoom out the
camera using the two buttons.
2. Iris Near/ Iris Far
These two buttons are used for controlling the iris lens. Proper adjustment will ensure the
correct exposure depending on the camera’s situation and the lighting levels.
3. Preset Pt.
If you want to set a preset point for viewing, you have to enter a number for the preset point first,
then pan/ tilt the camera to select the preset point a wanted position. After the number and
position are both determined, click on the “Set” button to complete the procedure.
You are able to clear a preset point at the same time; enter the number of that preset point, and
then click on the “Clear” button to clear off the preset point.
After the preset points are set, you can go to one of them immediately by one click. Enter the
number of the desired preset point, then click on the “Go” button to go to it.
9
10
11
12
13
7 8
1
2
3
4
5
6