Filter
Top Products
> Use the up/down arrow keys to move the marker by one line at a time.
> Use the left/right arrow keys to move backwards or forwards through the list one
page at a time.
> When you have completed your programming session, press the yellow function
key in order to store the data in memory.
> Press the TV/Radio key in order to return to normal operation.
IMPORTANT NOTICE !!!
Ensure that the receiver has received and stored the basic time. This is shown on the dis-
play during Standby mode. If this is not the case, you should select a channel with an auto-
matic time signal, such as ARD in Germany, and switch this on for approximately 30
seconds, so that your receiver can acquire the current time data.
After this procedure, the current time should be displayed in Standby mode.
7 Changing the Basic Programming
If for some reason you are not satisfied with the preprogrammed settings of your receiver,
you can alter the list of channels according to your own preferences. This function is also
required in order to sort the programmes identified in a Search run.
You should note the following:
Your receiver features two programme/channel lists, the User List and the Total List.
The User List includes those channels you can select by means of the numeric key pad, and
by using the channel up/down keys.
The Total List includes all channels.
If you do a search in this list, new programmes will be shown in yellow, and can be transfer-
red from the Total List to the User List.
7.1 Adding/Deleting Channels
To add new channels to the user list, or to delete channels, proceed as follows:
> Press the Menu key to display the Main Menu.
> Use the up/down arrow keys to mark TV Programmes if you wish to add TV
channels, or Radio Programmes, if you wish to add radio stations.
> Confirm with the OK key.
The sub-menu >Programmes will be displayed
30
bed_anl_ViaCam_engl_2.qxd 30.03.01 14:21 Seite 30