Filter
Top Products
10
Connections and initial set up
10.Deactivating the programming of the
satellite or cable receiver -
Ye s is selected to
deactivate the programmer. In that case,all your
satellite recordings will have to be programmed from
your satellite or cable receiver (this is the
recommended setting).Leave Ye s selected and press
OK.
11. IR controller connection - Refer to the diagram on page 8, follow the instructions on
the screen and press
OK.
12. Enter the receiver code - Now key in your
receiver’s satellite code number (refer to the table on
the next page), then press
OK to validate. If the
brand or model of your satellite or cable receiver is
not shown, try other numbers in the list displayed. If
unsuccessful, contact your retailer.
Note:Your DVD recorder asks you to display channel 2 on the satellite receiver. However, with some receivers,
it is preferable to display channel 0, 02 or 002.
13. Press OK to start the test - The DVD recorder sends a signal to your satellite receiver
via the infrared controller cell.A configuration menu will appear as the satellite receiver
positions itself on channel 12 (check that channel number 12 appears on the display panel of
the satellite receiver,sometimes fleetingly,and even if no picture is visible on the TV screen).
If the satellite receiver is not on channel 12, select No with the C or B keys and press
OK.
Your DVD recorder sends a new command to the
satellite receiver.(Several tests are possible, depending
on the brand of your satellite receiver).
If the satellite receiver goes on to channel 12, select
Ye s with the C or B keys and press
OK.If
unsuccessful, repeat the settings, starting at step
11, but
with the satellite receiver positioned on channel 0, 02
or 002 instead of 2.
A channel sorting window will appear.The picture of the selected channel is shown in the
background.Refer to page 7 to sort the stored channels or set the time on your DVD recorder
if necessary.
Your DVD recorder is now ready to control your satellite receiver to program
recordings.
2_DTH8540-50_en.qxd 11/08/05 11:40 Page 10