Filter
Top Products
63
No Image on Display Screen
For TV
Is the aerial connected properly? Are the plugs connected tightly to the aerial socket? Is the
aerial cable damaged? Are suitable plugs used to connect the aerial? If you are in doubt,
consult your dealer.
No Image means that your TV is not receiving any transmission. Have you pressed the
correct buttons on the remote control? Try once more.
For Monitor
Check that power cord of the Display has been connected securely into wall outlet or
grounded extension cable or strip.
Display is equipped with electronic power switch, it will remain power-off in case of any
power failure. It is necessary to push power switch again to power-on the display. Check
that LED on front of display is green.
Check that Video (Signal) Cable from the Display has been securely and correctly con-
nected to the 15-pin Video Connector on the rear panel of the Computer.
Check that Video Card is firmly seated in card slot of Computer motherboard.
Check that the Brightness and/or the Contrast adjustments of the Display have not been
turned down to minimum levels.
Sound
You can not hear any sound. Did you perhaps interrupt the sound, pressing key?
Are external speakers connected to the TV?
Sound is coming from only one of the speakers. Is the balance set to one direction extreme?
See Sound menu.
Remote Control
Your TV no longer responds to the remote control. Press the / DTV key on the
remote control once more. Perhaps the batteries are exhausted. If so you can still
use the buttons on the control panel at the top of your TV.
Have you selected the wrong menu? Press
/ DTV key to return to TV mode or
press M key to return to the previous menu.
No solution
Switch your TV set off and on. If this does not work, call the service personnel; never attempt
to repair it yourself.
50052932-1552UK (TOSHIBA UK)17 INCH TFT-IDTV-WO WM-dilek p65 11 05 2004 15:3063