Filter
Top Products
7
Removing the Pedestal Stand
1) Carefully laythe front of the unit face down on a flat,
cushioned surface such as a quilt or blanket. Leave
the stand protruding over the edge ofthe surface.
Note: Extreme care should always be used when
removing the pedestal stand to avoid damage to
the LCD panel.
2) Remove the stand screws shown in the diagram
below.This will allow removal of thepedestal stand.
3) Once you have removed the screws holding the
pedestal stand in place, remove the pedestal stand
from theTV.
L3400USeries
40" TV.
VESAMountingPattern
50"TV.
I h Hook Sturdy strap
Two stand screws (as short as possible)
(Sample Illustration)
VESAMounting Pattern
Two stand screws L Hook Sturdy strap
(as short as possible)
(Sample Illustration)
CAUTmON: Always place the TV on the floor or a
sturdy, level, stable surface that can support the
weight of the unit. To secure the TV, use a sturdy strap
from the hook(s) on the rear of the TV to a wall stud,
pillar, or other immovable structure. Make sure the
strap is tight, secure, and parallel to the floor.
FCCDeclarationof Conformify
ComplianceStatement(Part15):
Toshiba 40L3400U and 50L3400U Television
models comply with Part 15 of the FCC Rules.
Operation is sut!ject to the ILllowing two conditions:
(1) This device may not cause harmful imerf_rence, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
The party responsible tbr compliance tothese rules is:
Toshiba America Information Systems, Inc.
9740 Irvine Blvd., Ila-ine, CA 92618. Ph: 800-631-3811
Note: This equipment has been tested and found to
comply with the limits fore Class B digital device,
)ursuant to Part 15 of the FCC Rules. These litnits are
designed toprovide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
)articular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by removing and applying
)ower to the equipment, the user is encouraged to try
to correct the interference by one of the following
measures.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on acircuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radioiTV technician
for help.
Caution: Changes or modifications to this equipment
not expressly approved by Toshiba could void the
user's authority to operate this equipment.
WirelessRadio
For product available in the USA Canada market, only
channel 1-11 can be operated. Selection of other channels is
not possible. The device could automatically discontinue
transmission in case of absence of inl5rmation to transmit,
or operational failure. Note that this is not intended to
_rohibit transmission of control or signaling infbrmation or
the use of repetitive codes where required by the technology.
The device could automatically discontinue transmission in
case of absence ofinl\_rmation to transmit, or operational
failure. Note that this is not intended to prohibit
transmission of control or signaling infbrmation or the use
ofrepetitive codes where required by the technolog?_ If this
device is going to be operated in 5.15-5.25GHz frequency
range, then it is restricted to an indoor environment onlv.
Important: Any changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to operate
this equipment.