Filter
Top Products
116
Picture and Sound Controls
Adjusting the picture
* Backlight: Adjusts the brightness of the entire screen. When in video mode
and no signal is input, this selection is set to 0. (Settings are stored in
memory.)
Some settings cannot be adjusted in the following cases:
❖ AutoView is selected
❖ TheaterLock is set to On
To adjust the picture quality:
1 Press the MENU button. Select SETTINGS, PICTURE, the
setting you would like to adjust (Backlight, Contrast,
Brightness, Color, Tint, or Sharpness).
2 Press the (/ arrow) buttons to adjust the setting. Press the
EXIT button.
❖ Any picture settings that you adjust affect the current input only.
You can adjust the picture quality separately for each input.
❖ Depending on a Sharpness value, the Edge Enhancer effect may
be reduced.
To reset to the factory defaults:
1 Select the picture mode you want to reset.
2 Press the MENU button. Select SETTINGS, PICTURE,
Reset, and then press the OK button.
A confirmation screen appears.
3 Press the ( / arrow) buttons to select Yes, and then press the
OK button.
Contrast Lower Higher
Brightness Darker Lighter
Color Paler Deeper
Tint Reddish Greenish
Sharpness Softer Sharper
Selection Pressing ( ) Pressing ( )
NOTE
NOTE