Filter
Top Products
34
Connecting Your TV
Connecting a digital audio system
To control the device(s):
Point the TV remote control toward the front of the TV and press
the button for the desired function. The signal passes from the
remote control through the TV to the device via the IR Blaster
cable. For more information, see “IR Blaster Setup” on page 55.
(Sample Illustration) Controlling the device(s) - remote control
The IR pass-through feature does not support all IR controlled
devices. Satisfactory quality may not be attainable with certain
devices.
If you cannot locate the device’s infrared sensor:
1 Turn off the device.
2 Starting at the device’s lower-left corner, place the end of the
device’s remote control (with the infrared emitter) so it touches
the front of the device. Press the POWER button.
(Do not use the TV’s remote control for this step.)
3 If the device turns on, the sensor is located where the remote
control touched the device.
4 If the device does not turn on, move the remote control slightly
to the right and press the POWER button again.
5 Repeat the previous steps if necessary.
Connecting a digital audio system
The TV’s Digital Audio Out terminal outputs a Dolby
®
Digital or
2-channel down-mixed PCM (pulse-code modulation) signal for
NOTE