Filter
Top Products
English - 29
System Setup
Presetting the Stations
Automatically
Open “MENU”
With the DVD in Stop press the MENU button.
1
Select “Setup”
Using the buttons, move the selection bar to
“Setup” then press
or OK to select.
2
Select “Install”
Using the buttons, move the selection bar
to “Install”, then press
or OK to select.
3
Select “Auto Setup”
Move the selection buttons to “Auto Setup”
then press
or OK button to select from the
following options:
4
Programme
Press or OK button.
A message appears, indicating that any channels
already preset on the DVD Recorder-VCR will be
deleted.
5
Programme
Programme
Press [OK] to continue
[Menu] to exit
Press OK to start the auto
scaning.
• The first frequency band is scanned and the first
station found is displayed and stored. And the
DVD Recorder-VCR searches for the second
station and so on.
• When the automatic scanning procedure has
finished, the DVD Recorder-VCR switches
automatically to programm 1.
• The number of stations automatically stored by
the DVD Recorder-VCR depends on the num-
ber of stations that it has found.
6
Programme
You do not need to preset the stations if you have
already set them automatically (see Plug & Auto Set Up
on page 27).
Your DVD Recorder-VCR contains a built-in tuner used
to receive television broadcasts.
You must preset the stations received through the tuner.
This can be done:
• Plug & Auto Set up (see page 27)
• Automatically
• Manually (see page 30)
If you wish to cancel the auto scanning before the
end, press the OK button.
• The time and date are set automatically from
the broadcast signal. If the signal is weak or
ghosting occurs, the time and date may not be
set automatically.
• Once the auto scanning procedure has finished,
some stations may have been stored more than
once; select the stations with the best reception
and delete the ones no longer required.
7