Filter
Top Products
13
Introduction
Inserting batteries
Caution:
Never throw batteries into a fire.
Notes:
Be sure to use AAA size batteries.
Dispose of batteries in a designated disposal area.
Batteries should always be disposed of with the environment in mind. Always dispose of batteries in accordance with
applicable laws and regulations.
If the remote control does not operate correctly, or if the operating range becomes reduced, replace batteries with new
ones.
When necessary to replace batteries in the remote control, always replace both batteries with new ones. Never mix
battery types or use new and used batteries in combination.
Always remove batteries from remote control if they are dead or if the remote control is not to be used for an extended
period of time. This will prevent battery acid from leaking into the battery compartment.
Remote control basics
Press POWER to turn the DVD/VCR on or off.
Select your desired operating mode (DVD or VCR) using VCR DVD.
(DVD or VCR indicator on the front panel will show you which mode is selected.)
Press CH + or CH – to move through the channels one channel at a time.
The ▲/▼/◀/▶ are also used to navigate on-screen menu system.
You can directly access specific channels using Direct channel selection buttons (0–9).
Each press of VCR DVD on the remote control, switches the screen between the VCR screen (VCR mode) and the
DVD screen (DVD mode).
Operation
Aim the remote control at the remote sensor and press control buttons to
operate.
Operate the remote control within 30° angle on either side of the remote
sensor, up to a distance of approx. 7 meters.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
1
Open the battery
compartment cover in the
direction of the arrow.
2
Install two “AAA” batteries
(supplied), paying attention
to the polarity diagram in the
battery compartment.
3
Replace the compartment
cover.
Approx. 7 meters
2K60121A.indb 132K60121A.indb 13 1/12/2007 3:50:04 PM1/12/2007 3:50:04 PM