Filter
Top Products
24
Basic setup (VCR)
To set DAYLIGHT SAVING TIME
You can set the DAYLIGHT SAVING TIME automatically or
manually.
1
Press VCR MENU.
Press SET + or – to select “SYSTEM SETUP”, then
press ENTER.
2
Press SET + or – to select “DAYLIGHT SAVING
TIME”, then press ENTER.
3
Press SET + or – to select one of the options, then
press ENTER. Press VCR MENU until the MENU
screen is cleared.
ON: for manual setting
(forward one hour)
OFF: for manual setting
(back one hour)
AUTO: for automatic setting
(read XDS in the signal)
When you want to set the DAYLIGHT SAVING TIME
manually, on the first Sunday in April you set to “ON”,
and on the last Sunday in October you set to “OFF”.
Notes:
When shipped from factory, the DAYLIGHT SAVING TIME is
set to “AUTO” position.
When the clock is not set, DAYLIGHT SAVING TIME setting
is not available.
When there is no DAYLIGHT SAVING TIME in your area,
always select “OFF” position in step 3.
•
•
•
Manual clock setting
1
Press VCR MENU.
2
Press SET + or – to select “SYSTEM SETUP”, then
press ENTER.
3
Press SET + or – to select “CLOCK SET”, then press
ENTER.
4
Press SET + or – to set the month, then press
ENTER.
5
Set the day, year and time as in step 4.
6
After setting the clock, date and time starts
functioning automatically.
To make corrections any time during the process
Press CANCEL repeatedly until the item you want to
change blinks, then press SET + or –.
Note:
After a power failure or disconnection of the power, the timer
settings will be lost. In this case, reset the present time.
If the AUTO CLOCK process did not set the date and time
correctly, you must set them manually for timer recording and
DAYLIGHT SAVING TIME.
Setting channels automatically
TV/CABLE selection
Preparation:
Turn ON the TV and select the corresponding video
input.
Press VCR DVD selector to select the VCR mode.
(The VCR mode indicator will light.)
•
•
1
Press VCR MENU. Press SET + or – to select “CH
SETUP”, then press ENTER.
2
Press SET + or – to select “TV/CABLE”.
3
Press ENTER to select the TV or CABLE mode.
The arrow indicates the selected mode.
•
TV - VHF/UHF channels
CABLE - Cable TV channels
CH SETUP
TV
ADD/DELETE
CABLE
+/–/ENTER/MENU
AUTO CH MEMORY
4
Press VCR MENU until the menu screen is cleared.
Note:
You can’t select “CH SETUP” if you set the channel to “L1” or
“L2”.
1
Repeat above step 1 and press SET + or – to select
“AUTO CH MEMORY”.
2
Press ENTER.
Auto tuning will begin. The channel display will
count up and when finished, the screen returns to
normal.
•
Tuner setting
This DVD/VCR is equipped with a channel memory feature
which allows channels to skip up or down to the next channel
set into memory, skipping over unwanted channels. Before
selecting channels, they must be programmed into the DVD/
VCR’s memory. In addition to normal VHF and UHF channels,
this DVD/VCR can receive up to 113 Cable TV channels. To use
this DVD/VCR with an antenna, set the TV/CABLE menu option
to the TV mode. When shipped from the factory, this menu
option is in the CABLE mode.
2K60121A.indb 242K60121A.indb 24 1/12/2007 3:50:10 PM1/12/2007 3:50:10 PM