Filter
Top Products
22
Basic setup (VCR)
22
Basic setup (VCR)
Preparation:
Turn ON the TV and select to the corresponding
video input.
Press VCR DVD selector to select the VCR mode.
(The VCR mode indicator will light.)
•
•
1
Press VCR MENU.
The VCR menu screen will appear. Press SET + or
– to select “SYSTEM SETUP”, then press ENTER.
If you use the unit for the first time, press VCR
MENU, instead of the “SYSTEM SETUP” menu
screen of the main menu screen in step 2 may
appear.
•
MENU
TIMER REC SET
AUTO REPEAT
ON OFF
ON OFF
SAP
CH SETUP
SYSTEM SETUP
〈+/
-
/ENTER/MENU〉
2
Press SET + or – to select “LANGUAGE”, then press
ENTER.
SYSTEM SETUP
CLOCK SET
LANGUAGE/IDIOMA/LANGUE
NO NOISE BACKGROUND
AUTO CLOCK
STANDARD TIME
DAYLIGHT SAVING TIME
ON OFF
ON OFF
〈+/
-
/ENTER/MENU〉
3
Press SET + or – to select the desired language:
English (ENGLISH), Spanish (ESPAÑOL) or French
(FRANCAIS), then press ENTER.
4
Press VCR MENU repeatedly until the menu screen
is cleared.
Setting the video channel
When a TV is connected with the 75 ohm coaxial cable
only.
To view playback of a recorded tape or DVD disc, or to watch a
program selected by the VCR’s channel selector, the TV must
be set to channel 3 or 4 (video channel).
For a push-button TV tuner
If CH 3 or 4 corresponding to the video channel cannot
be tuned on your TV, proceed as follows: set the VCR
3/4 channel selector and the TV to CH 3 or 4, playback
a prerecorded tape and tune the TV to receive a sharp
color picture from the video cassette recorder. Refer to
your TV owner’s manual for details.
Setting the video channel Setting the language
Note:
If the unit does not operate properly, or No key operation
(by the unit and/or the remote control): Static electricity,
etc., may affect the player’s operation. Disconnect the AC
power cord once, then connect it again.
Setting the language
You can choose from three different languages (English,
French and Spanish) for the on-screen display.
Notes:
Both the VCR and the DVD have their own player menus
41
.
If no buttons are pressed for more than 60 seconds, the
VCR MENU screen will return to normal TV-operation
automatically.
•
•
1
Press and hold 3 or 4 on the remote control for 3
seconds in standby mode.
The video channel will start to flash for 3 seconds
in the display window.
•
2
Press POWER to turn on the DVD/VCR.
3
Press VCR DVD selector to select the VCR mode.
The VCR mode indicator will light at the right of
the display window.
•
4
Turn ON the TV and set to CH 3 or 4 to correspond
with the channel selected in step 1.
5
Press TV/VCR to select the VCR position.
The VCR indicator will appear at the upper left of
the display window.
•
6
Select any channel to receive a TV station in your
area.
The channel number will appear on the screen for
about 4 seconds.
2K60121A.indb 222K60121A.indb 22 1/12/2007 3:50:09 PM1/12/2007 3:50:09 PM