Filter
Top Products
42
Function setup (DVD)
■ Screen Saver
The screen saver operates when you leave the unit in
DVD stop mode for approx. five minutes.
The DVD VIDEO logo moves randomly on the screen.
Off:
Screen Saver function is invalidated.
On:
Screen Saver function is made effective.
■ Display
On screen display can be switched on or off when you
press any buttons.
Off: On screen displays do not appear when you
press any buttons.
On: On screen displays appear when you press
any buttons (factory setting).
■ Picture Mode
There are two types of source content in pictures
recorded in DVD video discs: film content (pictures
recorded from films at 24 frames per second) and
video content (video signals recorded at 30 frames per
second). Make this selection according to the type of
content being viewed.
Auto: Select this selection normally.
The DVD player automatically detects
source content, film or video of playback
source, and converts that signal in the
progressive output format in an appropriate
method.
Film: The DVD player converts film content
pictures in the progressive output format
appropriately. Suitable for playback of film
content pictures. The progressive output
feature will be most effective under this
selection.
Video: The DVD player filters video signal, and
converts it in the progressive output format
appropriately.
Suitable for playback of video content
pictures.
Note:
Depending on the disc, pictures may be cut off or doubled. In
this case, select “Video”.
■ JPEG Interval
You can continuously playback all JPEG files
automatically.
After the selection below, the disc will start playback on
JPEG files which have been recorded.
Off:
Plays back one file at a time.
5 Seconds:
Plays back images in the form of a slide show at 5
second intervals.
10 Seconds:
Plays back images in the form of a slide show at 10
second intervals.
15 Seconds:
Plays back images in the form of a slide show at 15
second intervals.
■ Night Mode
Night Mode enables you to control the dynamic range so
as to achieve a suitable sound for your equipment.
Off: It plays back at the recording level on the disc.
On: Loud sound such as explosion is toned down
slightly when played back. This is suitable
when it is connected to a stereo.
Notes:
This function works only when the disc recorded with
Dolby Digital is played back.
The level of Night Mode may differ depending on DVD
video disc.
•
•
■ QSound
This DVD video player equipped with a “QSound”. It can
produce the effect of being in a cinema or a concert hall.
Off: The QSound is disengaged.
On: The QSound operates.
Notes:
The QSound setting can also be changed with AUDIO on
the remote control
36
.
This function works only when the disc recorded with
Dolby Digital is played back.
When this function works, the volume might changed.
When the voice is distorted, turn off QSound.
•
•
•
•
■ Digital Out
You can select the digital output sound format corresponding
to your system connection.
PCM:
Change Dolby Digital to PCM for the output.
Select when connected to a 2 channel digital stereo
amplifier.
Bitstream:
Disc audio bitstream data will be output.
Off:
There is no sound output from DIGITAL AUDIO
OUT jack.
Note:
Even if you select “Bitstream”, MPEG Audio will be output
in PCM format.
■ Parental control setting
Some discs are specified as not suitable for children.
Such discs can be limited not to playback with the unit.
1) Press ▲ or ▼ to select “Parental”, then press
ENTER. “Enter Password” screen will appear.
2) Press “0000” using Number buttons (0–9).
(Please note, this is pre-setting password of this unit).
Then press ENTER. The parental level list will appear.
• Level Off: The parental control setting does not
function.
• Level 8: Virtually all DVD software can be played
back.
• Level 1: DVD software for adults cannot be played
back.
3) Press ▲ or ▼ to select from the level 1 to level 8.
Then press ENTER. The limitation will be more severe
as the level number is lower.
4) Press OPEN/CLOSE to activate Parental control
setting.
2K60121A.indb 422K60121A.indb 42 1/12/2007 3:50:20 PM1/12/2007 3:50:20 PM