Filter
Top Products
Menu Operations
21
4.3 Multi Search
When you enter the “Multi Search” menu a
window like the one beside will open.
1. On “Satellite” item press [OK] to open
the satellite list. Then press [Channel
Up/Down] to move the highlight and
press [OK] to mark/unmark and
[MENU] to finish the selection. You can
select several satellites in this menu.
The system will use DiSEqC1.0/1.1,
DiSEqC1.2 and USALS functions to
search the marked satellites and scan channels.
2. On “FTA Only” item, press [Volume Up/Down] to select scanning of all
channels or just scanning of free channels. If you select “Yes” it will scan
free channels only.
3. On “Scan Channel” item, press [Volume Up/Down] to select the scanning
range from TV + radio channels, only TV channels or only radio channels.
4. On “Scan Mode” item, you can select “Preset Scan” or “Network Scan” to
scan preset transponders or network transponders of the selected satellite.
5. Select “Search” and press [OK] to start scanning. In the lower part of the
window the progress of scanning and the found channels are displayed.
6. Press [MENU] to cancel the scanning.
4.4 TP Scan
When you enter “TP Scan” menu a window
like the one beside will be displayed.
1. On “Satellite” item, press [Volume
Up/Down] to select the satellite you
want to scan or press [OK] to open the
satellite list for selection.
2. On “TP Index” item use [Volume
Up/Down] to select the desired
transponder or [Red] and [Green] key
on the RCU for the related functions.
¾ When you press [Red] it will display “New Carrier” in “TP Index” item.
You have to set the parameters of “TP Frequency” and “Symbol Rate”
for this new transponder. Therefore use the number buttons of the
RCU. The available range are “3000~13450MHz” and
“1000~45000KS/s”.