Filter
Top Products
Menu Operations
35
Update Software(receiver to receiver)
1. Connect master and slave receivers with twisted RS-232C cable.
2. Power on the master receiver and make it in standby mode input number
key.
3. Turn on slave receiver to begin update.
4. Input the password “123” by remote control to update the software.
5. After update, it will display “-End” on slave panel.
6. Turn off slave receiver, disconnect twisted RS-232C cable and restart it.
Notes: Input the password “123” to update the software.
Input the password “456” to update the data.
Input the password “789” to update the software and data.
Input the password “369” to copy the whole flash.
Update Software(Computer to receiver)
1. Connect your PC and receiver with twisted RS-232C cable.
2. Turn on the receiver.
3. Startup the software of “upgrade_Ali.exe” on your PC, press “Select” key
and select “*.bin”, then select port. Press “start” on your PC. Upgrade will
begin.
4. After upgrade, the receiver will display “-End” on panel.
5. Turn off the receiver, disconnect twisted RS-232C Cable and restart it.
Notes:
You need a 9-pin twisted RS-232C cable(pin-2 to pin-3, pin-3 to pin-2, pin-5
to pin-5).
You can not turn off the slave receiver until it display -End” on the panel.
Down Loading Method
CABLE CONNECT MEASURES
1. CABLE CONNECT MEASURES:
a) Cable Layout