Specifying Protocol Settings
2-20
Using a TCP/IP Network (Windows/UNIX)
2
MAC Address: Specify the MAC Address of the machine. Every second digit
is separated by “-” (“:” for UNIX).
Input Example (Windows): arp -s 172.20.88.125 00-00-85-05-70-31
Input Example (UNIX): arp -s 172.20.88.125 00:00:85:05:70:31
NOTE
•
If you are using IBM-AIX, enter "arp -s ether <IP Address> <MAC Address>."
•
Note that in IBM-AIX language, the word “ether” means Ethernet.
3
Execute the applicable command below to set the IP address
for the network board.
ping <IP Address> -l 479 (for Windows)
ping -s <IP Address> 479 (for Solaris 1.x/2.x)
ping <IP Address> 479 (for IBM-AIX)
ping <IP Address> 487 (for HP-UX)
ping -s 479 <IP Address> (for Red Hat Linux)
ping -s 480 <IP Address> (for Turbolinux)
IP Address: Specify the same IP address that you specified in step 2 above.
Input Example (Windows): ping 172.20.88.125 -l 479
NOTE
•
The term “-l” above is not “1” (one), but is the small letter of “L”.
•
To set the subnet mask and gateway address, you must use an FTP Client. For
details on the procedure, proceed to step 1 in “Using an FTP Client,” on p. 2-43.
Using an FTP Client
You can use an FTP Client to specify the subnet mask and gateway address.
1
Start up the MS-DOS prompt or the Command prompt.
If you are using UNIX, display the Console screen, and then log on as a
superuser.
2
Execute the following command.
ftp <machine’s IP address>
