206 Power Tools EZConfig Utilities
MX6 Reference Guide E-EQ-MX6RG-E-ARC
Key Value Description
AimerDelayALR 500 Similar to AimerDelay, but for ALR mode only
Trigger 42
Default: 42
(On/Scan Key)
Sets the key used by ScanDemo to initiate a
scan/decode. The key is registered as a system hot
key, it cannot be registered as a hot key by any
other applications.
ScanTimeout 9000
Default: 2000
(2 seconds)
Specifies the decode time out in 1/1000th seconds.
If a barcode is not decoded within the specified
timeout period an audio and visual notification
will indicate that an error occurred.
ScanAbort 1 Specifes the behavior of the decoder upon release
of the trigger key.
0 = The decoder will scan as long as specified by
the ScanTimeout parameter
1 = Releasing the trigger key will cause the
decoder to stop scanning.
ScanInterval 0 Time interval between scanning attempts
(milliseconds), when in AutoScan mode.
ScanMode 1 Specifies the decode mode. If 1, the decoder is in
normal mode. If 2, the decoder works in ALD
(Aggressive Linear Decode) mode.
LinearRange 3
Default: 3
Specifies the linear search range to be used while
in ALD mode. The range is 1 to 6. A value of 1
indicates a tight vertical range near the aimer. A
value of 6 indicates a vertical range of the entire
height of the imager.
PrintWeight 4 1-7: Sets the decoder's PrintWeight parameter:
adjusts the way the decoder reads Matrix symbols.
If the image engine will be seeing consistently
heavily printed Matrix symbols, a print weight of
6 or 7 may improve reading performance.
ReplaceCRwithCRLF 0 0/1: If set to 1, replaces the carriage return (13) in
the decoded data with carriage return and line feed
(13,10).
0=Disable
1=Enable
GoodScanWav Default=”” Specifies a wave file to be played on a successful
decode/data reception. The wave file should be an
8 bit, 11KHz, mono, PCM file. If no wave file is
specified, the default beep will be utilized. Use the
‘sound’ setting to enable and disable audio
notification. NOTE: The Window's “Good
Decode” sound defined in the control panel or the
GoodScanFreq parameter take precedence over
this option, if defined.
