Reset or Reboot 41
E-EQ-MX6RG-E-ARC MX6 Reference Guide
• As soon as the Certificate Authority (CA) certificate and server authentication certificates
are downloaded to the expected location in the MX6, place a copy of the certificates in
the IPSM folder. The certificates must be re-installed using CertAdd each time a hard
reset occurs. When the current date has been set and the certificates installed, soft reset
the MX6 to authenticate the supplicant (MX6 radio).
See Also: “Accessing Files in Flash Memory”.
Upgrading the Mobile Device OS
To ensure that changes you make that involve upgrading drivers, adding CAB files or service
packs or a new kernel are saved, follow the procedure below:
1. Delete REGBACKUP.HHP from the \IPSM folder.
2. Perform the appropriate Before-you-Proceed step from the table below:
Overwriting a CAB File
If you are overwriting a CAB file with a new version,
rename the existing CAB file or delete it.
Loading a new UTILS File
If you are going to be loading a new UTILS_XX.CAB file
delete AUTOINSTALL.EXE, AUTORUN.INI, and
AUTORUN.EXE from the \IPSM directory. Failure to do
this may result in an AUTORUN.INI that does not match
the installed kernel.
Installing a Service Pack
If you are installing a service pack delete the older service
packs.
Installing a new KERNEL
If you are installing an update file containing a new kernel,
delete the entire IPSM\AUTOINSTALL directory before
proceeding.
3. Install software.
4. Hard reset (cold boot) the mobile device to clear the registry.
5. Configure the mobile device.
• See “Getting Started”.
• The radio, flash card, virtual keyboard and scanner parameters need to be
reconfigured after a hard reset.
• Any programs that were not saved to the IPSM folder need to be reinstalled.
6. Soft reset the mobile device afterwards.
7. Verify the changes.
8.
Tap Start (or the
) | Utils (or Power Tools) | RegBackup to permanently save the
settings.
