76 Programs
MX6 Reference Guide E-EQ-MX6RG-E-ARC
Profile Info tab
Factory Default Settings
Profile Info
Profile Info Network profile and network name
Peer to peer group Ad Hoc mode disabled
Associate with any available
network
Disabled
Do active scan Enabled
Authentication profile Default
Figure 4-11 Profile Info Tab
Network Profile Enter the name of this record. This is the name that appears in the
Configured Networks list and, by default, is the same as the
broadcast SSID. Note that there is nothing special about the name
"default". You could configure any other record similarly and it
would behave the same way.
Network Name This is the SSID of the access point. If the access point broadcasts its
SSID, then this value may be derived from the Available Networks
list. If the SSID does not broadcast, then you must manually enter
the value here.
Peer-to-Peer Group (ad
hoc mode)
Select this option to have two or more client workstations
communicate with each other without the benefit of an access point.
You should also select Do Active Scan and, in the WEP
Management page, enable Use key for data encryption while
entering a common key for both sides. WPA is not supported in this
mode.
Do active scan Select this option whenever the access point (or client, for ad hoc
mode) is not broadcasting its SSID.
