2. The current settings for switch 00 are now displayed on the bottom line of the
display. If the settings for this switch are the way that you want them, go to
step 4.
❐ The top line shows the settings normally seen in a machine just delivered
from the factory.
3. To change the required setting, press a
number from 0 to 7 corresponding to the
digit that you wish to change.
Example: 0 . The value of the digit
changes, in this case from 0 to 1.
Each switch contains 8 digits, which act as on/off switches for various
features. The digits are numbered from 7 to 0; the setting of digit 7 is shown
at the left side of the display and digit 0 is at the right.
4. Either:
❐ Scroll through the switches with ↑ and ↓ until the required switch
appears. Then go to step 3.
❐ Finish: Yes Function
The user parameter switches are outlined below.
Switch 00 - Home position settings
Digit Purpose
0
Stamp 0: Off
1: On (successfully scanned documents will be marked)
1
2
Resolution Digit 2 Digit 1 Setting Digit 2 Digit 1 Setting
0 0 Normal 1 0 Darken
0 1 Lighten 1 1 Do not use this.
3
4
Resolution Digit 4 Digit 3 Setting Digit 4 Digit 3 Setting
0 0 Standard 1 0 Super Fine
0 1 Detail 1 1 Do not use this.
5
Transmission mode 0: Memory transmission
1: Immediate transmission
6
If you change any of the contrast, resolution, transmission mode, stamp, or halftone
settings before making a transmission, then:
0: The setting(s) will not return to the home position after the transmission.
1: The setting(s) will return to the home position after the transmission.
7 Halftone 0: Off 1: On
USER PARAMETER PRINT LIST
DEFAULT: 01000000
SWITCH00: 01000001
YES
TO END
HOW TO USE THIS MANUAL
11
