Filter
Top Products
ADCP-75-192 • Issue 2 • June 2007
Page 24
© 2007, ADC Telecommunications, Inc.
The software in the Hubmaster continues to send requests to all configured Hub Nodes to
determine if there are any BIM modules that have come online. When a new BIM module is
located, the Hub Config Process creates an “Unconfigured” tenant in the BTS Connection MIB.
This can be seen by noticing that the Tenant ID in the BTS Connection MIB is “Unconfigured”,
where X is 1-96. Also, it can be seen that the CPU Rack and Chassis IDs are filled in and the
BIM I2C Bus/Slot information is filled in.
For ease of setup, when a new BIM module is found, the required BTS Connection MIB is
automatically filled in with default values. These values can be changed manually by the user
(see section 6.2.6. for details).
3.3.2.1 Setting the Tenant Name
Tenant Name is the name of the Wireless Service Provider (WSP). The allowable value is a
string length of 1-17 characters. The MIB field is:
transceptBtsConnectionTable.transceptBtsConnectionTenantName.
3.3.2.2 Setting the BTS ID
The BTS ID identifies the BTS being used by the WSP for this particular tenant. Since WSPs
may have more than one base station (BTS) in the system, it is important to uniquely identify
each one. The allowable value is a string of 1-8 characters. The MIB field is:
transceptBtsConnectionTable.transceptBtsConnectionBTSID.
3.3.2.3 Setting the BTS Sector
The BTS Sector field of the BTS Connection MIB is an enumerated value, where the allowable
selections are ALPHA (0), BETA (1), or GAMMA (2). The MIB field is:
transceptBtsConnectionTable.transceptBtsConnectionBTSSector.
3.3.2.4 Setting the Tenant Band
The Tenant Band field of the BTS Connection MIB is an enumerated value, where the allowable
selections are the bands supported by the Digivance CXD/NXD system, currently:
No Band (0) - no band selected, will not result in a configured tenant
US1900A (1) - PCS band A
US1900B (2) - PCS band B
Note: In EMS, the BTS Connection MIB (Tenants Table) is accessed from the menu tree
by selecting Configuration-Tenants. The object names given here (for example, Tenant
Name) are the names that the objects have in the Tenants Table.