Filter
Top Products
ADCP-75-192 • Issue 2 • June 2007
Page 42
© 2007, ADC Telecommunications, Inc.
3.8.2.1 IP Address
This entry (transceptRanNodeTable.transceptRanNodeIPAddress) displays the IP Address of
each RAN attached to the Hubmaster node. RAN IP addresses are assigned by DHCP. This
entry is automatically entered by Digivance CXD/NXD system software.
3.8.2.2 Hostname
transceptRanNodeTable.transceptRanNodeHostname
This entry displays the hostname of each RAN attached to the Hubmaster node. This entry is
automatically entered by Digivance CXD/NXD system software. Changing the default
hostname is not recommended, but can be accomplished.
3.8.2.3 Pole Number
transceptRanNodeTable.transceptRanNodePoleNumber
This entry displays the number of the pole on which each RAN is installed. In conjunction with
the Site ID, this is the mechanism used to pinpoint any RAN’s physical location. GPS can also
be used, where available. The pole number may be 15 characters long.
3.8.2.4 Site ID
transceptRanNodeTable.transceptRanNodeSiteID
This entry displays the RF Network’s Site ID where each RAN is installed. In conjunction with
the Pole Number, this is the mechanism used to pinpoint any RAN’s physical location. GPS can
also be used, where available. The Site ID may be 64 characters long.
3.8.2.5 RucXPaY Connection
transceptRanNodeTable.transceptRanNodeRucXPaYConnection, where X=1-3, Y=1-2
These entries manually record the RF connection path between the RAN UpConverter’s RFA
outputs and the antenna.
For example, if the RFA attached to RUC A1’s “1/3” output is connected to a PCS ADB RFA,
then transceptRanNodeTable.transceptRanNodeRuc1Pa1Connection should be set to
“pcsADB”. This data is best gathered at installation time. Repeat for all RUCs and RFAs as
necessary.
Note: For tenant information propagation to occur, this field must be populated.
Note: For tenant information propagation to occur, this field must be populated.