Filter
Top Products
ADCP-75-192 • Issue 2 • June 2007
Page 30
© 2007, ADC Telecommunications, Inc.
3.4.8 Setting Reverse Cable Loss
transceptTenantOAMTable.transceptTenantReverseCableLoss
Reverse Cable Loss is a object in the Tenant OAM MIB to allow the signal loss due to cabling
between the base stations and the Digivance CXD/NXD system to be factored into the reverse
gain management processing. This object has a valid range of values of 0 to 450, which is 0 to
+45 dB in 1/10 dB units. The maximum cable loss between the BTS and the BIM is 45 dB.
3.4.9 Using Tenant Reset
transceptTenantOAMTable.transceptTenantReset
Tenant Reset is a object in the Tenant OAM MIB that will allow all of the hardware that is
associated with a tenant to be reset. This functionality is not currently supported in the
Digivance CXD/NXD software.
3.4.10 Enabling FGC/RGC
transceptTenantOAMTable.transceptTenantForwardAGCDisable
and
transceptTenantOAMTable.transceptTenantReverseAGCDisable
The Forward and Reverse Gain/Continuity Management processes can be disabled on a per
tenant basis using the enable/disable objects in the Tenant MIB. These MIB fields are
enumerated types with values “Enabled” = 0, and “Disabled” = 1. The reason for the inverse
boolean logic is so that the desired default values are set to be zero, which is the MIB default
value.
3.4.11 Using Tenant Mode
transceptTenantOAMTable.transceptTenantMode
Tenant Mode is a object in the Tenant OAM MIB that will allow the tenant to be put into a
special mode such as “disabled”, or “test”,. This functionality is not currently supported in the
Digivance CXD/NXD software.
3.4.12 Enabling/Disabling Delay Compensation
transceptTenantOAMTable.transceptTenantForwardDelayCompensationDisable
and
transceptTenantOAMTable.transceptTenantReverseDelayCompensationDisable