Filter
Top Products
Chapter 2. Hardware Setup
9
Installation
Installation of the VS482 is simply a matter of plugging in the appropriate
cables.
To install the switch, refer to the installation diagram below as you perform the
following steps:
1. Use an HDMI cable to connect the HDMI input port on the video display
device to the HDMI output port on the rear of the VS482.
2. Use HDMI cables to connect the HDMI output ports on the source
device(s) to the HDMI input ports on the VS482.
3. Plug the provided power adapter into an appropriate AC power source;
plug the power adapter cable into the Power Jack on the VS482.
4. Connect your audio devices (such as speakers or AVRs) to the Stereo
Audio Ports or Digital Audio Ports.
5. (Optional) To edit the VS482 system settings through the RS-232 port,
connect the hardware / software controller here.
This completes the basic installation of the 4-Port Dual View HDMI Switch.
You may now power on the display and source devices.
3
1
2
Hardware / Software
Controller
HDMI A/V
Source Devices
HDMI Output Device
4
AVR
AVR
5