Filter
Top Products
DiSEqC 1.0 Connection
All our receivers are designed to be DiSEqC 1.0 compatible. This allows
multiple antennas to be connected to the STB at the same time.
If you have two or more fixed antennas or LNBs then we recommend you
use a DiSEqC 1.0 swtich.
Connect the coaxial cable from the first LNB to the LNB 1 or LNB A input
connector of the DiSEqC swtich.
Do the same for any other LNBs that you have.
Connect one end of a Coaxial cable to the RX output connector of the
DiSEqC swtich, connect the other end to the LNB IN socket on the STB.
DiSEqC 1.2 Connection
Please refer to 34 page.
Connection of satellite antenna
To the digital receiver, you can connect either a single satellite antenna
directly or LNB of multi-feed equipment.
Reference
11
TV with Motorised System and Positioner
Connect one end of RCA/Cinch cable to the RCA/Cinch socket on the back of
the STB and the other end to a RCA/Cinch socket on your TV.
If your TV doesn’t have a RCA/Cinch socket, connect one end of RF cable to the
RF OUT on the back of the STB and the other end to a RF input socket on
your TV.
Connect the coaxial cable from the LNB of your motorised system to the LNB IN
socket on the STB.
Connect the motor cables to your positioner.
(please refer to the manual for your positioner and actuator)
Connect your positioner to your TV if necessary.
Set-up 5
Reference