Filter
Top Products
27
Motorized System
It is used to set the DiSEqC 1.2 motor by Eutelsat specifica-
tion. If you wish to use this system, please refer to page 34
for instructions.
Service Search OSD
If you press the EXIT key during the search, service
search stops and the searching menu appears.
When you find all the services the following picture
appears.
Before saving it, you can select the service you want to
delete.
Found services OSD
The picture above shows services that are found after
manual search.
You can mark the services that you don’t want to save
using the (red) key, these services will turn grey. To
unmark a service, select the service and press the (red)
key on it again.
Press the OK key to save, or press the EXIT key to exit
without saving.
Then Manual Search menu appears. When you exit all
menus, the first service of the found service list is played.
In the bottom of found service picture, network, the informa-
tion of transponder and the number of found service that the
services belong to are displayed. The deleted service by the
(red) key is excepted from counting of the number of
sevices.
At the bottom of the screen that shows the services found in
the search, the information of transponder and the number of
found services that the service belongs to are displayed. The
deleted service (using the (red) key) is not included in this
number.
Free means the empty part of all service memory, this is the
amount of space available to store other services in the
future.
i
i
i
i
Guide of
Main Menu