Filter
Top Products
Digital Video Recorder Control Center | en 105
Bosch Security Systems User Manual F01U | 2.0 | 2008.12
• Video loss: Sends an e-mail when a video signal from the camera has stopped because of a
cable disconnection or malfunction of a camera.
• Motion detect: Sends an e-mail when motion detection has occurred.
• Power on/off: Sends an e-mail when power is on or off.
• Disk full: Sends an e-mail when the HDD has fully recorded.
• Admin PW changed: Sends an e-mail when the administrator password has changed.
DDNS
• User ID: Enter the DDNS registered user name.
• Password: Enter the user password in [User ID].
Note:
The DDNS function is serviced using a TCP 8245 port by “No-IP” (http://
www.no-ip.com/).
In case the DVR is used in the network system with a firewall, open the
TCP 8245 port so that DDNS data can get into firewall. For more detail
on firewall setup, ask your network administrator and/or network service
provider.
Emergency
• Notifi cation: Notify the Alarm Notifi er about unit operating information according to your
notifi cation settings.
• IP Address, Port: Enter the IP Address and port number of the Alarm Notifi er program installed
on the PC. The factory default port for this function is 9002. However, in some cases it is
better to change this port number for added fl exibility or security. If desired, change the port
number (1025 ~ 65535). You can set up to 9 IP address and port numbers.
6.7.5 System setup
Figure 6.37 The System setup window
Date/Time settings
Set the date/time options.